Sludge & Biosolids Processing Solutions

  1. STM-Aerotor™ Biological Nutrient Removal 6/16/2015

    The STM-Aerotor™ Biological Nutrient Removal System uses Integrated Fixed Film and Activated Sludge (IFAS) technology as part of a process that provides biological nutrient removal for municipal and industrial wastewater treatment.

  2. Wipes Ready Technology 4/30/2015

    Are you wipes ready?
    Wipes and rags are clogging pumps and damaging wastewater treatment systems. NEW Wipes Ready technologies from JWC will keep your systems running efficiently.

  3. SedVac Sediment Removal System 4/28/2015

    SedVac’s unique design funnels the sludge and scrapes the floor, resulting in consistent solids removal of 3 percent concentration while wasting less water than traditional pipe systems.

  4. 10K Series Muffin Monster 4/27/2015

    The 10K Series Muffin Monster is a compact grinder, tough on solids in sludge and sewage applications. It fits into areas with limited space requirements while still providing the necessary power for downstream protection. This simplified design makes it a best cost solution to your sludge and sewage pumping problems.

  5. The Flygt 2600 Series 4/22/2015

    With more than 60 years’ experience supplying dewatering pumps to some of the most demanding sites around the world, Xylem has designed the Flygt 2600 series to stand up to the toughest conditions.

  6. TWISTER® Low-Speed Aerator 2/18/2015

    Long-lasting performance, and the highest oxygen-transfer rates of any mechanical aeration system on the market.

  7. CleanFlo™ Monoscreen® Fine Screen 1/9/2015

    The WesTech CleanFlo™ Monoscreen® is a highly efficient, self-cleaning fine screen that is being used in a wide variety of wastewater and process water treatment applications. Utilizing a reliable blade and drive system, the Monoscreen creates a progressive step motion that allows the screenings to be evenly distributed while minimizing water level surges.The result is a screenings capture ratio of 82.5 percent.When matched with WesTech’s CleanWash™ SWP/CPS dewatering unit, the combination maximizes the solids capture rate for almost any headworks operation while minimizing the amount of solids for disposal.

  8. OxyStream™ Oxidation Ditch 1/8/2015

    The OxyStream™ Oxidation Ditch from WesTech Engineering has proven to be the ideal equipment for biological wastewater treatment applications throughout the world. It combines vertically mounted, low-speed surface aerators with an oxidation ditch design to maximize oxygen transfer efficiency while maintaining the greatest flexibility for power turndown. In addition, the OxyStream™ has greater side water depths and fewer required aerators than a conventional brush rotor or disc rotor oxidation ditch. The vertical slow-speed surface aerator eliminates maintenance-prone horizontal shafts, pillow block bearings, and drive units near the water surface. Above all, the OxyStream™ Oxidation Ditch provides energy savings and produces predictable, high-quality effluent.

  9. Q-Press 12/26/2014

    The incredible Huber Technology Q-Press for dewatering municipal sludge is providing impressive results in cake solids, polymer consumption, and capture rates. With its slow rotating auger the Q-Press can handle the toughest of sludge with ease.

    The Q-Press can quietly run unattended by taking advantage of the fully automatic operation leaving plant personnel to be freed up to attend to other duties. By using only a fraction of the horsepower of other technologies, intermittent wash cycles, and frugal polymer dosing the Q-Press provides low cost of ownership.

  10. SRT Solar Active Dryer 12/26/2014

    The basic principle of the HUBER SRT system is drying of sludge in a solar greenhouse using the available solar radiation. A special sludge turning system performs both spreading and turning of the sludge as well as its transport from one side to the other.