CONTROLSTIK II™ Rinse Tank System
The Myron L CONTROLSTIK II Rinse Tank System dramatically reduces the amount of water used in continuous flow rinse tanks. At the same time, it automatically maintains optimum water purity, ensuring effective rinsing
Click Here To Download:
•Datasheet: CONTROLSTIK II™ Rinse Tank System
The Myron L CONTROLSTIK II Rinse Tank System dramatically reduces the amount of water used in continuous flow rinse tanks. At the same time, it automatically maintains optimum water purity, ensuring effective rinsing.
Since water flows only when parts are rinsed, you save money on water bills, sewer use charges, and waste water treatment expenses.
|
Applications |
| Continuous-flow rinse tanks |
| Circuit board manufacturing |
| Electroplating |
| Wastewater |
|
Features |
| IP65 / NEMA 4X Rating Water and Corrosion Resistant Enclosure |
| 316 Stainless Steel Hardware |
| Reliable Solid-State Electronics |
| Automatic Temperature Compensation to 25ºC / 77ºF up to 82ºC / 180ºF |
|
Valve Features Anti-Hammer Closing and Conduit Connector, Adjustable Flow Control and Manual Override |
How it works
The three parts of the CONTROLSTIK II System are easily installed. The CONTROLSTIK II (conductivity sensor) is set at a tolerable contamination level and submerged in the tank. Water cannot flow into the tank until drag-in from rinsed parts causes the contamination level in the tank to rise above the pre-set point. The CONTROLSTIK II (sensor) then signals the solenoid valve to open, adding fresh water. As soon as this fresh water dilutes the contamination to the tolerable pre-set level, the CONTROLSTIK II (sensor) closes the valve.
Engineering Specifications
Rinse water usage shall be minimized by means of automatic conductivity control systems. They shall consist of a temperature compensated conductivity sensor, corrosion resistant one-inch solenoid valve and transformer box which safely reduces line power to the probe and sensor. Enclosure shall be fiberglass with heavy rubber gasket and 316 stainless steel. Circuitry shall be solid-state and unaffected by changes in voltage between 105 and 125 volts. Setpoint adjustment shall be on sensor to minimize tampering. Rinse tank controls shall be Myron L Model 597 or approved equal.
Click Here To Download:
•Datasheet: CONTROLSTIK II™ Rinse Tank System