Retractable Sampling Probe

150 psi. rated

Retractable sampling probes can be inserted into a pressurized main up to 150 psi. A mechanical assist may be needed for pressures above 100 psi.

The operator does not have to shut down and depressurize the main before removing the sampling probe. Using caution, the operator can remove the sampling probe from the main as long as the pressure is below 150 psi.

The unit includes a 45 degree bevel tip and a sight alignment guide. Face the 45 degree bevel tip upstream for collection of the sample. After installation, the operator can view the sight alignment guide to make sure the 45 degree bevel is in the proper position.

A single stainless steel hook and chain locks the sampling probe securely to the main connection.

A stainless steel limit chain stops the sampling probe from extending past the main connection during withdrawal.

The solution tube adapter and packing nut thread together, compressing the 300 series o-ring which forms a tight seal around the outer diameter of the sampling probe.

• Brass Ball Valve
• Brass Solution Tube Adaptor
• Brass Packing Nut
• 300 Series O-Ring Gasket
• Stainless Steel Restraint Hook
• Stainless Steel Limit Chain
• 45° bevel tip w/ alignment guide