Video | May 3, 2016

Kupferle Foundry - #9800i-GENESIS Turbine Powered Automatic Flushing Device With Chlorine Analyzer

The Eclipse i-Series model #9800i-GENESIS is the newest Intelligent Flushing & Monitoring Station Kupferle offers to maintain safe residual levels and remove DBPs from consumers' water. This permanently installed station incorporates a built-in chlorine analyzer to measure and record disinfectant residual levels based on a programmed sampling schedule.

Using the Programmable Logic Control (PLC) interface, users can input minimum and desired residual levels, an initial blow-off time, and a maximum flushing duration. The unit will then operate under these parameters and will flush when detected residuals are below minimum prescribed levels and flush only the exact amount of water needed until desired residuals are attained. All residual and flushing data is recorded and can be transferred to an electronic spread sheet program via a micro-SD card or can be transmitted using a SCADA system. Thermal enclosure has a insulation rating of R-9 and is equipped with 250 Watt heater/fan and four zone thermostats. Unit is self powered incorporating a water turbine and a 24VDC battery bank (no outside power source need). The unit uses any flushed water to run the turbine which charges the batteries that provide power to the analytical equipment. Additional analyzers/sensors can be incorporated including, but not limited to: temperature, PH, psi, turbidity, conductivity and ORP. Sampling lines are heated using self-regulating heat trace. Unit is fully maintainable from above ground.