Hydro-Dyne Engineering Introduces Hydro-Flo Water/Wastewater Screen

The Hydro-Flo is a water and wastewater screen specifically designed to protect sensitive process equipment such as membranes and provides no screen bypass or carry-over, and the proprietary Hydro-Flo Bypass Gate eliminates the need for a separate bypass channel. The Hydro-Flo is made entirely of stainless steel and is available with perforated plates, wire mesh, or laced link grids ranging from 1 mm to 25 mm openings. No submerged drive parts and complete enclosure for safety, aesthetics and odor control make this screen an excellent choice for varied municipal applications.

The Hydro-Flo has been successfully installed in numerous locations around the world including Ft. Collins, CO where the Hydro-Flo proved crucial in removing pine needles and other organic debris from their raw water intake supply that were causing severe blockage and production loss. The Hydro-Flo was designed and built to install in the existing channel which minimized both cost and project completion time.

The Hydro-Flo Screen is designed and manufactured, along with a full line of screens and screening handling equipment, by Hydro-Dyne Engineering, Inc. in Oldsmar, FL USA guaranteeing acceptance under the "Buy American" provision pursuant to section 1605 of the American Recovery and Reinvestment Act of 2009. For more information, visit: www.hydro-dyne.com.

SOURCE: Hydro-Dyne Engineering, Inc.