Product/Service

Catalytic & Thermal Oxidizers

Branch can provide standard design or custom built oxidation systems for thermal destruction of volatile organic compounds (voc) and other gases that can be eliminated by thermal destruction.

Branch can provide standard design or custom built oxidation systems for thermal destruction of volatile organic compounds (voc) and other gases that can be eliminated by thermal destruction.

THERMAL OXIDATION

Thermal Oxidizer.jpgYour Thermal Oxidizer will combine the right combination of high temperature, turbulent conditions, and residence time to assure complete combustion of volatile organic compounds or other contaminants in the air stream.

Thermal Oxidizers can be built to handle any size volume of gas. However, even with thermal recovery, most units are less than 20,000 cfm.

 

 

 

 

CATALYTIC OXIDATION

Catalytic Oxidizer.jpgAt lower VOC concentrations (2500 ppm), catalytic oxidation reduces the cost of fuel significantly.

Typically, operating temperatures will be 1/3 of those used in a thermal oxidizer. In many cases, only 500-600º F (260-320º C ) is required for good performance.

Shop fabricated capacities of up to 25,000 cfm are available.

 

SOLVENT CONCENTRATION

Solvent Concentration.jpg (18637 bytes)Where large volumes must be handled, we can provide a solvent concentration stage using a special media which captures the voc and then is regenerated. This allows the released voc gas to be sent to a much smaller oxidizer. The result is a reliable system with low operating cost.

Contact us for further information.

 

 

 

  • All performance levels are guaranteed.
  • Any design configuration can be provided, including vertical and horizontal.
  • All safety features with UL, FM or other approved components as needed
  • Complete engineering, including tail gas treatment from one source..