Amacan P - Submersible Motor Pump With Axial Propeller

Wet-installed, submersible motor pump with axial propeller in ECB design for installation in discharge tubes, single-stage, single-entry, explosion protection to ATEX II G2 T3.
Design
Wet-installed, submersible motor pump with axial propeller in ECB design for installation in discharge tubes, single-stage, single-entry, explosion protection to ATEX II G2 T3.
Applications
Irrigation and drainage pumping stations, stormwater pumping stations, handling of raw and clean water in water and effluent treatment plants, of cooling water in power stations and industrial plants, industrial water supply systems, water pollution and flood control systems, aquaculture.
Overview of technical data
Type of bearing |
Rolling element bearings |
Casing partition |
Radially split |
Drive |
Electric motor |
Drive frequency |
50 Hz / 60 Hz |
Type of drive |
Electric motor |
Drive voltage |
Low voltage |
Connection to power supply |
380 V, 400 V, 690 V, 3~ |
Explosion protection |
ATEX II 2G T3 |
No. of impeller entries |
Single entry |
Impeller material (EN standard) |
1. 4517;AL-BRONZE |
Type of installation |
Close- coupled |
Type of coupling |
None |
Type of lubrication |
Grease lubrication |
Max. permissible fluid temperature |
104 °F |
Nozzle position |
In- line |
Pump set location |
00 |
Shaft material (EN standard) |
1. 4057.05;1.4021.05 |
Suction characteristics |
Non- priming |
Type of casing |
Tubular casing |
Type of impeller |
Axial; Open;Propeller |
Casing material (EN standard) |
JL 1030 |
eClass assignment |
36410101; 36410106 |
Free passage |
255 mm |
Maximum head |
39, 37 ft |
Minimum head |
2, 62 ft |
Installation position |
Vertical |
Shaft seal type |
Mechanical seal |
Main applications |
Energy; Mining / Dredges;Water;Waste water / sewage |
Casing material |
Cast iron |
Maximum drive rating |
938. 72 hp |
Type of installation |
Stationary |
Maximum flow rate |
25. 200 m³/h |
Minimum flow rate |
360 m³/h |
Maximum speed of rotation |
2 rpm |